Tianjin Weimaraner annual production and processing cutting fluid, micro-emulsion cutting fluid, cutting fluid emulsion, water-based rust-proof cutting fluid, rust-proof cutting oil extreme pressure range, cutting fluid in the course of a lot of details need to pay attention, cutting fluid dilution water should be used to better water quality. accurate knowledge of cutting fluid concentration, try to use the densitometer to control, not based on personal experience. After the end of the process, the cutting fluid hose to flush out chips and granulated slag surface of the machine. Open the machine guard doors so moist air to disperse machining area. In the process, as long as the cutting fluid continuously spray coating on bare metal surface, rust-proof cutting fluid additive can prevent the metal surface rust machine's workspace, but When the machine down after several hours, may cause corrosion. Because in the process, the water coolant in the evaporator, so that the machine processing zone to form a nearly 100% relative humidity. Once the machine off, the temperature began to drop, moisture in the air will condense on the surface of metal parts due to condensed water will gradually dilute rust additives, so that the cutting fluid retention in the gradual loss of corrosion resistance. Therefore, these measures is very important. regular testing coolant concentration and pH. Periodic complete replacement machine tool cooling system to reduce the chance of bacterial growth cutting fluid before and after a physical performance test, electrochemical properties of the bend or change in the testing process. 

keywords: Cutting fluid, cutting fluid micro-emulsion, the emulsion,